The Heating Season Begins…

As autumn progresses, daily temperatures begin to drop.  And so the heating season begins.  It’s that time of year when particular attention should be paid to making sure that your furnace is in good operating condition.  This means that the blower motor and burners should be thoroughly cleaned, old filters should be replaced, and the cyclic operation tested to make sure that everything works properly.  The cyclic operation is tested simply by turning up your thermostat to a temperature above the ambient where the burners should ignite and the blower motor should begin circulating air.  When the thermostat is turned down to a temperature below the ambient, the burners should turn off and the blower motor should also stop after a few minutes.  If you furnace is in a closet, make sure that anything stored in the closet that is combustible is removed and stored elsewhere or discarded.  If you will be using a gas logs unit, be sure that the burner and logs are free from dust and lint before using.  In addition, be sure that the unit is properly ventilated, your chimney damper is open or you have a window open to draw in air with a non-vented appliance.  Gas ranges are NOT intended to be used as heating appliances – please do not light all burners and keep it going indefinitely.  Carbon Monoxide can fill an enclosed room and become deadly.  Electric furnaces do not have this problem because they are not gas burning appliances.  However, heat can eventually cause wiring insulation to become brittle and short circuits can occur, leading to fires in homes and businesses.  When the heating demand is increased on boiler applications, pumps should be checked to make that water flow is not restricted and that all safety devices are operational.  Similarly, in geothermal applications water flow is critical in heat transfer between the heat source and the heat sink.  It is imperative that all piping, pumps and controls be inspected to assure proper operation and the prevention of loss due to fire.  Lastly, if you don’t know how to service your heating equipment, call a qualified service company!

<span>%d</span> bloggers like this: